Slope staples:
12″, 8 gauge, square top.
Heavy load — the blanket has to stay down through the first storm.
Water is the load, and it arrives all at once. Twelve-inch legs pass the reinforced layer and bed into subsoil; 8 gauge wire stays straight where 11 gauge bows and lifts the crown.
On a face, the staple is the only thing between the blanket and the ditch.
Blankets do not fail in the middle. They fail at the pin, when the leg is too short or too thin for the load water puts on it.
Legs through blanket, into subsoil
The blanket only holds if the staple passes the reinforced layer and beds into undisturbed ground below it.
8 gauge does not bow
Blanket tension on a 1:2 face bends 11 gauge wire. 8 gauge (Ø 4.2 mm) keeps the leg straight so the crown stays down.
Staples per slab of sod on a slope
The same count that holds turf holds a blanket edge: two to four through each unit, more as the face steepens.
To quote this job
- Face height and slope ratio
- Blanket or TRM type and weight
- Legs 8″, 10″ or 12″
- Gauge 8 or 9
- Barbed or plain
- Port and Incoterm
The slope list.
Twelve inches is the working length. Eight gauge is the working wire. Everything else here is a compromise for a gentler face.
| Size | Wire | Top | Pcs / box | Note |
|---|---|---|---|---|
| 12″ × 1″ × 12″ | 8 ga | Square | 250 | Heavy blanket and TRM work on steep faces; the standard slope staple. |
| 12″ × 1″ × 12″ | 9 ga | Square | 250 | Same reach with wire an installer can still hand-set. |
| 10″ × 1″ × 10″ | 9 ga | Square | 500 | Medium faces, jute and straw blanket. |
| 8″ × 1″ × 8″ | 8 ga | Square | 500 | Shallow slope, mat on firm ground. |
| 12″ × 1″ × 12″ barbed | 8 ga | Square | quote | Saturated or sandy face; barbs per leg formed to order. |
Other applications
Blanket lifting after rain?
Send the face height, slope ratio and blanket weight. We match leg length and wire to the load.