Shade net staples:
8″–12″, 8–9 gauge.
Wind load — a net turns a gust into a pull on every staple.
Netting is a sail. The staple has to hold tension, not just the fabric weight: twice the steel of 11 gauge, legs below the tilled layer, and a 2″ crown so the pull spreads across the weave instead of tearing one hole.
A net is a sail, and the staple is the whole anchor.
Everything that fails under netting fails at the same place: the leg pulls out of loose ground, or the crown tears through the weave.
Steel per staple, versus 11 ga
Wire area rises with the square of the diameter: 8 gauge (Ø 4.2 mm) carries 2.25× the steel of 11 gauge (Ø 2.8 mm) at the same length.
Legs under the tilled layer
Wind anchors let go in the loose top 4–6″. Ten to twelve inch legs reach ground that has not been worked.
Crown across the weave
A wide crown bridges several strands, so the gust arrives on the staple instead of on one torn hole in the net.
To quote this job
- Net type, width and span between posts
- Legs 8″, 10″ or 12″, crown 2″
- Gauge 8 or 9
- Barbed, screw or plain shank
- Volume and season
- Port and Incoterm
The netting list.
Long legs first, then the crown, then the shank. On a windy site the order never changes.
| Size | Wire | Top | Pcs / box | Note |
|---|---|---|---|---|
| 10″ × 2″ × 10″ | 8 ga | Square | 500 | Wind-exposed runs with shade cloth or bird net, 2″ crown. |
| 12″ × 2″ × 12″ | 8 ga | Square | 250 | Long spans and sandy ground; the leg that stays put. |
| 12″ × 1″ × 12″ | 8 ga | Square | 250 | Narrow edges and heavy section of net. |
| 8″ × 2″ × 8″ | 9 ga | Square | 500 | Sheltered sites, hand install, price-sensitive. |
| 10″ × 2″ × 10″ screw | 8 ga | Square | quote | Threaded shank in sand or ash; formed to order. |
Nets lifting at the corners?
Tell us the span, the wind exposure and the ground. We size the leg and the crown for the load, not for the price.