Drip tubing staples:
11 gauge, 6″, galvanized, round top.
Light load — the staple only has to stop the tape lifting off the surface.
A drip line sits in wet ground for years, so the wire matters as much as the shape. Round crown saddles the tape, 6″ legs reach past the loose topsoil, zinc coating holds at the crown where moisture never leaves.
Holding a tape is a shape problem before it is a weight problem.
The tape only lifts; it never pulls sideways. So the crown decides whether the run stays put — depth and gauge decide how long it stays put.
Legs past the loose layer
Orchard and row-crop ground is tilled and soft in the top 2–3″. The staple only holds when the legs reach firm soil under that.
11 gauge, hand-set
Thin enough to push in beside an emitter without dragging the tape; stiff enough that the crown does not bow under tension.
No pinch point on the tube
A square crown presses on two lines of the tape. The arc spreads the load and leaves the emitter run clear.
To quote this run
- Legs and crown, inches
- Gauge, bright or galvanised
- Top: round or square
- Pcs per box, boxes per pallet
- Volume per shipment
- Port and Incoterm
The drip-tubing list.
Crown stays at 1″ unless the tape is wide or the run is exposed. Everything here ships 72 boxes to a pallet unless the size says otherwise.
| Size | Wire | Top | Pcs / box | Note |
|---|---|---|---|---|
| 6″ × 1″ × 6″ | 11 ga | Round | 1,000 | Galvanised. Standard for drip tape and soaker hose up to 7/8″ O.D. |
| 8″ × 1″ × 8″ | 11 ga | Round | 500 | Loose or sandy ground — same crown, deeper anchor. |
| 6″ × 1″ × 6″ | 10 ga | Round | 1,000 | Where machinery or foot traffic crosses the line. |
| 6″ × 1″ × 6″ | 9 ga | Round | 1,000 | Compacted ground, long runs, heavier hose. |
| 6″ × 1″ × 6″ | 11 ga | Square | 1,000 | Tape and fabric pinned in one pass. |
Drip tape moving under the crown?
Send the tape O.D., the soil type and the volume. We answer with the gauge and the pallet count, not a brochure.