Five jobs,
five staple specs.
Start from the load, not from the catalogue.
A drip tape, a fabric edge, a shade net on a windy ridge, a blanket on a 1:2 face and a salt-spray fence line all ask different things of the same piece of bent wire. These five pages pair each job with the size, gauge and finish that holds.
Each scenario has its own size list and its own note on why.
Five detail pages, each with the sizes we run for that job, the packing and container count, and the placement numbers that keep the staple down.
Drip tubing
Round crown saddles the tape so the run cannot lift. Galvanised wire, because the crown sits in moisture all season.
Weed barrier & fabric
Two crown widths. A 2″ crown spreads the pull where the fabric edge is exposed; 8″ legs for graded ground.
Shade net & netting
A net is a sail. Twice the steel of 11 gauge, legs below the tilled layer, 2″ crown across the weave.
Slope & erosion control
Twelve-inch legs pass the blanket and bed into subsoil; 8 gauge stays straight where 11 gauge bows.
Coastal & wet sites
No coating to lose. 304 for wet ground and fertigation, 316 for salt spray and brackish water.
The whole selection in one table
Legs, crown, wire — in that order. Finish is the last decision and it is driven by water, not by price.
Four finishes, one staple
Everything above is formed on the same line. What changes the service life is the surface and the shank.
Bright wire
Bare, uncoated, cheapest per piece. Rusts as it grips; fine for dry sites and one-season work.
Galvanised
Zinc layer against moisture. The default for irrigation, fabric and anything under a blanket.
Barbed or screw
Two to four barbs per leg, or a threaded shank, for sand and ash. Formed to order, quoted.
Stainless 304 / 316
No coating to consume. 304 for wet ground, 316 for chloride — salt spray, brackish water.
Not sure which page fits?
Describe the job — what is pinned, what ground, what weather — and we answer with a size and a pallet count.